The original Adafruit Motorshield kit is one of our most beloved kits, which is why we decided to make something even better. We have upgraded the shield kit to make the bestest, easiest way to drive DC and Stepper motors. This…

This Adafruit shield makes it easy to use a 16x2 Character LCD.
Unfortunately, these LCDs do require quite a few digital pins, 6 to control the LCD and then another pin to control the backlight for a total of 7 pins. That's almost…

The Relay Shield (ie, four 5V relay module) is a small current signal control equipment commonly used power electronic modules, enabling high-power single-chip control devices, widely used in the SCM system to make smart home…

Use these to stack shields on your Arduino! These are standard 6-pin, 8-pin and 10-pin 0.1" spacing female headers...with a twist! The pins are extra long which means you can use these to stack shields! The legs are 10.5mm (0.42")…

Brand new and better than ever, we've replaced our Adafruit GPS shield kit with this assembled shield that comes with an Ultimate GPS module. This GPS shield works great with either UNO or Leonardo Arduinos and is designed to log…

The next generation Proto-ScrewShield is a dual-purpose prototyping shield. Now only does it have a large 0.1" grid prototyping area but it also extends the Arduino pins to sturdy, secure, and dependable screw terminal blocks. You…

Works with the Uno! This prototyping shield is the best out there (well, we think so, at least). It works with UNO, NG, Diecimila and Duemilanove Arduinos. You can use it with a Leonardo but it will not break out the hardware SPI…

The Arduino Ethernet Shield connects your Arduino to the internet in mere minutes. Just plug this module onto your Arduino board, connect it to your network with an RJ45 cable (not included) and follow a few simple instructions to…

You want to make a cool Arduino robot, maybe a hexapod walker, or maybe just a piece of art with a lot of moving parts. Or maybe you want to drive a lot of LEDs with precise PWM output. Then you realize that the Arduino has only a…

Adding quality audio to an electronic project is surprisingly difficult. Here is a shield for Arduinos that solves this problem. It can play up to 22KHz, 12bit uncompressed audio files of any length. It`s low cost, available as an…

This shield kit pack will allow you to turn any Arduino into an AVR chip burner! It is specifically designed for people who want to program Atmega328P`s to turn them into Arduino bootloader chips using an AVR-ISP sketch, but it…

Here`s a very handy Arduino shield.

You can get going quickly - saving data to files on any FAT16 or FAT32 formatted SD card, to be read by any plotting, spreadsheet or analysis program

Please note that this item does not come…